1 Push button to open filter cover.
2 Pull the old cartridge down. Pull out the filter.
NOTE:If the filter is difficult to remove, pressure in the line can be relieved by using the water dispense.
a.) Turn off the water supply
b.) Run the dispenser with the water supply off for approximately 1 minute. The filter should now come away easily.
3 Holding the new filter in your hands, remove all packaging and the sanitary end-cap.
4 Insert the new filter into the manifold hole until it is seated.
5 Push the cover back up until it clicks back into place.
6Run water from the dispenser for 5 minutes (approximately 3 gallons) to clear the system and prevent air from entering the system.
NOTE: Initial flow rate may be slower than expected. Full flow rate should be restored within 24-36 hours.
7Reset the indicator light by holding the LIGHT/FILTER button down for 3 seconds.
8Check the new filter installation for any possible leaks. If a leak is detected, uninstall and then reinstall the filter as instructed above.